desalination plant. The condenser is a heat exchanger that converts the steam received from the evaporator to liquid using the sea water as the cooling fluid. The key properties of the desalination plant surface condenser are:(1) heat transfer properties (thermal conductivity, convective heat
Desalination. Heat exchangers for heat recovery, heat rejection and brine heater sections. Refrigeration, ventilation and Air conditioning. Condenser, brine evaporator, heater etc. The upper working temperature for 90-10 and 70-30 Cu-Ni is normally about 250°C. Shell and Tube Evaporators and Condensers from devices. The condenser has a steel shell and tube sheet with rugged cast bonnets. These condensers are for fresh water duty. Small tonnage condensers include special multi-pass heads and are manufactured in very large quantities to provide the highest capacity per ton available. The condensers feature ¾ enhanced surface straight copper tubing roller
Condenser :It is a similar plate type heat exchanger as described above for the evaporator section. As the vapors rise they are condensed by the sea water . In this process the sea water gets heated and after the flow has been established the sea water is fed into the evaporator. Ejector pump :It supplies the condenser with sea water for cooling and brine/air ejector with jet water as well as feed water for Types of Heat Exchangers Used on Ship - Marine InsightOct 11, 2019 · This type of heat exchanger consists of concentric shape flow passages which help in creating a turbulence flow of a fluid which in turns increases the heat transfer efficiency. Initial installation cost is higher but highly efficient as compare to other types
Nov 12, 2019 · The most common definition of fouling in relation to heat exchangers is the deposition and accumulation of unwanted material such as scale, suspended solids, insoluble salts and even algae on the internal surfaces of the heat exchanger. Depending on the materials involved, this fouling can occur on both the primary and service surfaces of the Universal Heat Exchangers Ltd - Manufacturer of Sea water Sea water Heat Exchanger. Get Latest Price. Dimensions. 1446 x 5807 L x 12mm thk. Material. SA516 Gr.60/SA-266 Gr.2. Tubes. SA-179, 322 nos. TubeSheet.
alternative is the use of sea water heat rejection. This method utilizes a heat exchanger which has water pumped from the sea into one side to be used as heat rejection, in the other side the condenser water from the building is pumped to be cooled. The intention of this study is to make a comparison of the two individual systems with the same Copper Nickel :Condenser and Heat Exchange Systems
Your email address will not be published.*