For induced draught installations with fan diameters greater than 2.4 m the motor and speed reducer will normally be mounted below the tube bundles, with an extended drive shaft, as shown in Figure 2 There are normally at least two fans in each exchanger bay so that significant cooling is maintained in the event of a partial failure, and it is preferable for fans to cover at least 40% of the total bundle face area. Air Cooled Heat Exchangers Chart IndustriesAn air cooled heat exchanger (air cooler) removes heat from a liquid or gas into ambient air. Chart provides horizontal, vertical and multiple fan coolers with both forced and induced draft. Complete range of options including winterization, maintenance and header walkways, ladders, bugscreens, louvers, heating coils and warm air recirculation.
Air Fin Cooler . Air Fin Cooler (or) Fin fan Cooler or Air Fin Coolers are the same Air Cooling equipment. It also used for Heat rejecting from a hot process fluid to the surrounding atmosphere by using the atmospheric air as a cooling media.It works by making the object to be cooled have a larger surface area or have an increased flow of air over its surface, or both.Air cooling is a method Plate finned type Heat Exchanger , Plate - Air fin coolerA plate fin heat exchanger is transferred from one stream through the fin interface to the separator plate and through the next set of fins into the adjacent fluid. The fins also serve to increase the structural integrity of the heat exchanger and allow it to withstand high pressures while providing an extended surface area for heat transfer.
An ACHE is a device for rejecting heat from a fluid directly to ambient air.This is in contrast to rejecting heat to water and then rejecting it to air, as with a shell and tube heat exchanger and a wet cooling tower system. The obvious advantage of an ACHE is that it does not require water, which means that plants requiring large fin fan air cooled heat exchanger, fin fan air cooled heat offers 2,342 fin fan air cooled heat exchanger products. A wide variety of fin fan air cooled heat exchanger options are available to you, such as warranty of core components, local service location, and key selling points.
Features:Aluminum bar plate fin structure, coupled with high-performance air pump motor and high-strength fan leaves, in the complex working conditions for a long time to work.
Your email address will not be published.*